Product Parameters
- Category:Chargers & More
- Tags:11.1V Li-ion battery charger, 11.1V LiPo battery charger, 7.4V Li-ion battery charger, 7.4V LiPO battery charger, Li-ion charger, Li-Po charger, LiFePo4 battery charger, NiCD battery charger, NiMH battery charger, smart balance charger
- Item #:JTN-CHR-LN416
- Product Type:Charger
- Input:100-240V 50/60Hz
- Output:Charge current: 2.0A, Output power: Max 16W
- Charge Fits:Li-Po, Li-Fe 2-3S, Ni-MH/Ni-Cd 4-8sS
- Dimensions:Approx. 100*72*32mm
- Approx. Weight:135.0±10g
Features
• Smaller, Built-in power supply, working without additional adapter.
• Support Li-Po, Li-Fe, Ni-MH/Ni-Cd, multi-usage.
• The maximum current is 2.0A, less cell count can charge quickly.
• It can be protective when connect the wire inversely.
• The maximum charging current is adjustable, the small battery capacity can be switched to a small current to protect the battery.
Specifications:
• Input: AC 100V-240V 50/60Hz
• Battery type: Li-Po, Li-Fe, Ni-MH/Ni-Cd
• Cell count: Li-Po, Li-Fe 2-3S, Ni-MH/Ni-Cd 4-8sS
• Charge current: Max 2.0A
• Output power: Max 16W
Set the current
The current can be choose, there is two types (0.7A and 2.0A for default value) for setting the current.
Setting method: In standby mode, press and hold the Li-Po button for more than 2seconds can switch the current. (The red and yellow LEDs are 2 lighting normally on means the current have been switched to 0.7A, and if three LEDs are lighting at the same time, it representatives the current is 2.0A). Then you can press any key to exit the setting, and start to charging with pressing the corresponding battery button.The charger will restore to the default value (2.0 A) for each new charging.
Charging
1. Connect the charger to AC power.
2. The green light of charger is normally on, it means working.
3. If you need to switch the current to 0.7A, please set up according to the above steps.
4. Three keys to switch the battery type (green light: Li-po,yellow light: Li-Fe, red light: Ni-MH/Ni-Cd), press the keys, the corresponding light will light up.
5. Connecting the correct battery to the corresponding battery type, when the battery is the Ni-MH/Ni-Cd
please use tie line to connect.
6. Short press the corresponding keys of LED light (the corresponding keys of battery type), the light flashing, it start to charge.
7. Press the corresponding keys can stop charging in the process of charging, or when the battery is full and the LED light change to sustained lighting, then it can put out the battery.
Status Display:
LiPo/Li-ion Battery: Green LED, LiFePO4 Battery: Yellow LED, NiMH/NiCD Battery: Red LED
• Stand By: LED constant lighting
• Charging: LED flash
• Full Charged: LED constant lighting
LN416 Multifunctional Charger Manual
